Richard

This guide is to help you terminate the fabric rope cable.

If you are trying to install this cable into a 10mm cord grip onto a lampholder, then this hopefully will hlep you.

First off you will need to get yourself some sellotape.

Whenever you cut the cable or want to strip it you will need to put a piece of sellotape around the cable and cut on the sellotap.

This stops the fabric from fraying.

Once you have put the sellotape on the piece you want to strip use a knife or cutters to cut the fabric braid only not the pvc inner cores.(Please be carefull)

stripped-cable-with-sellotape.jpg 

Its hard to see but there is a small piece of sellotape around the end of fabric to stop it from fraying.

Make sure the sellotape does not go too far up cable as once you have installed cord grip you dont want to see the tape.

Now you can strip the pvc cable as normal again with cutters of a knife.

  stripped-cable-with-sellotape-inner-cores.jpg 

 

 

Once this has been done you can now start to put the cord grip pieces on.

Depending on what style of cord grip you go for this step will change.

I have gone for the metal cord grip as i think this looks the best with this cable.

3202-s2y.jpg

These come in 3 section the outer cover, the black inner grip and the thread to screw into lampholder.

Slide the outer cover onto cable NOTE: be carefull as the thread on the inside will pull the fibres on the fabric cable, just go slow.

  cord-grip-install.jpg 

 

After you slide the outer cover on, notice that i have to cut a leg from the black cord grip it self this is because the cable if too fat to neatly slide that piece on.

Now take the threaded part of the cord grip and thread it onto the lampholder, if you look on the inside of the lampholder there is a small grub screw, once the cord grip is screwed in you mus do this small screw up, that stops the cord grip from twisting away form lampholder.

  cord-grip-in-lampholder.jpg 

 

 

Now all you need todo is slide the cord grip cover and twist on.

  finished.jpg 

 

  finished-hanging.jpg 

The only downside to this cable is that it wont fit inside any 10mm threaded rods or spacers unless you can strip the rope around the cable.

 

Follow and join us on facebook
or visit
lampspares logo   lia logo

Proud to be members of the Lighting Industry Association.


Please note that any advice is given with the best intentions but cannot be confirmed that this may be all that is required for your project. All electrical work must be carried out by a competent person and all work should be fully tested before use.

Quote 0 0